Example Mode Page Dump

The results below were run under Windows XP using a HP 36 GB SCSI Disk.

smartmon-ux -J \\.\PHYSICALDRIVE1

Discovered HP 36.4G MAU3036NC S/N "KY010344" on \\.\PHYSICALDRIVE1 (Not Enabling SMART) [Bus/Port/ID.LUN=0/2/9.0](34732 MB)

Read-Write Error Recovery : Page [01h] (Factory, Current, Saved)

Automatic reallocation of write (AWRE) : 1, 1, 1

Automatic reallocation of read (ARRE) : 1, 1, 1

Transfer block (TB) : 0, 0, 0

Read continuous (RC) : 0, 0, 0

Enable early recovery (EER) : 0, 0, 0

Post error (PER) : 0, 0, 0

Disable transfer on error (DTE) : 0, 0, 0

Disable correction (DCR) : 0, 0, 0

Read Retry Count : 63, 63, 63

Correction Span : 255, 255, 255 {R/O}

Head Offset Count : 0, 0, 0 {R/O}

Data Strobe Offset Count : 0, 0, 0 {R/O}

Write Retry Count : 63, 63, 63

Recovery Time Limit : 30000, 30000, 30000

Disconnect-Reconnect : Page [02h] (Factory, Current, Saved)

Buffer full ratio : 0, 0, 0

Buffer empty ratio : 0, 0, 0

Bus inactivity limit : 1, 1, 1 {R/O}

Disconnect time limit : 0, 0, 0 {R/O}

Connect time limit : 0, 0, 0 {R/O}

Maximum burst size : 0, 0, 0 {R/O}

Enable modify data pointers (EMDP) : 0, 0, 0 {R/O}

Fair arbitration : 7, 7, 7

Disconnect immediate (DImm) : 0, 0, 0 {R/O}

Data transfer disconnect control (DTDC) : 0, 0, 0 {R/O}

First burst size : 0, 0, 0 {R/O}

Format Device : Page [03h] (Factory, Current, Saved)

Tracks per zone : 54, 54, 54 {R/O}

Alternate sectors per zone : 200, 200, 200

Alternate tracks per zone : 0, 0, 0 {R/O}

Alternate tracks per lun : 36, 36, 36 {R/O}

Sectors per track : 863, 863, 863 {R/O}

Bytes per sector : 512, 512, 512

Interleave : 1, 1, 1 {R/O}

Track skew factor : 216, 216, 216 {R/O}

Cylinder skew factor : 111, 111, 111 {R/O}

Supports soft sectoring (SSEC) : 0, 0, 0 {R/O}

Supports hard sectoring (SHEC) : 1, 1, 1 {R/O}

Removable Medium (RMB) : 0, 0, 0 {R/O}

Addresses assigned by surface (SURF) : 0, 0, 0 {R/O}

Rigid Disk Device Geometry : Page [04h] (Factory, Current, Saved)

Number of cylinders : 49158, 49158, 49158 {R/O}

Number of heads : 2, 2, 2 {R/O}

Starting write precomp : 0, 0, 0 {R/O}

Starting reduced current : 0, 0, 0 {R/O}

Drive step rate : 0, 0, 0 {R/O}

Landing Zone Cylinder : 0, 0, 0 {R/O}

RPL : 0, 0, 0 {R/O}

Rotational Offset : 0, 0, 0 {R/O}

Medium rotation Rate : 15000, 15000, 15000 {R/O}

Verify Error Recovery : Page [07h] (Factory, Current, Saved)

EER : 0, 0, 0

PER : 0, 0, 0

DTE : 0, 0, 0

DCR : 0, 0, 0

Verify Retry Count : 63, 63, 63

Verify Correction Span (bits) : 255, 255, 255 {R/O}

Verify Recovery Time Limit (ms) : 30000, 30000, 30000 {R/O}

Cache Control : Page [08h] (Factory, Current, Saved)

Initiator control (IC) : 0, 0, 0

Abort Pre-fetch (ABPF) : 0, 0, 0 {R/O}

Caching analysis permitted (CAP) : 0, 0, 0 {R/O}

Discontinuity (DISC) : 1, 1, 1 {R/O}

Size enable (Size) : 0, 0, 0 {R/O}

Write cache enable (WCE) : 1, 0, 0

Multiplication factor (MF) : 0, 0, 0 {R/O}

Read cache disable (RCD) : 0, 0, 0

Demand read retention priority : 0, 0, 0 {R/O}

Demand Write Retention Priority : 0, 0, 0 {R/O}

Disable Pre-fetch Transfer Length : 65535, 65535, 65535 {R/O}

Minimum Pre-fetch : 0, 0, 0 {R/O}

Maximum Pre-fetch : 0, 0, 0 {R/O}

Maximum Pre-fetch Ceiling : 65535, 65535, 65535 {R/O}

Force sequential write (FSW) : 1, 1, 1 {R/O}

LB cache segment size (LBCSS) : 0, 0, 0 {R/O}

Disable read-ahead (DRA) : 0, 0, 0 {R/O}

Vendor-specific bits (VSS) : 0, 0, 0 {R/O}

Number of cache segments : 8, 8, 8 {R/O}

Cache segment size : 0, 0, 0 {R/O}

Non cache segment size : 0, 0, 0 {R/O}

Peripheral Device Parameters : Page [09h] (Factory, Current, Saved)

Interface identifier : 0, 0, 0 {R/O}

Reselection retry count : 4, 4, 4 {R/O}

Force FAST-20 : 0, 0, 0

Force FAST-10 : 0, 0, 0 {R/O}

Force 8-BIT : 0, 0, 0 {R/O}

Control Mode : Page [0Ah] (Factory, Current, Saved)

TST : 0, 0, 0 {R/O}

TMF_ONLY : 0, 0, 0 {R/O}

D_SENSE : 0, 0, 0

GLTSD : 0, 0, 0

RLEC : 0, 0, 0

Queue algorithm modifier : 1, 1, 1

QErr : 0, 0, 0

DQue : 0, 0, 0

VS : 0, 0, 0 {R/O}

RAQ : 0, 0, 0 {R/O}

UA_INTLCK_CTRL : 0, 0, 0 {R/O}

SWP : 0, 0, 0 {R/O}

RAERP : 0, 0, 0 {R/O}

UUAERP : 0, 0, 0 {R/O}

EAERP : 0, 0, 0 {R/O}

ATO : 0, 0, 0 {R/O}

TAS : 0, 0, 0 {R/O}

Autoload mode : 0, 0, 0 {R/O}

Ready AER holdoff period : 0, 0, 0 {R/O}

Busy timeout period : 0, 0, 0 {R/O}

Extended self-test completion time : 984, 984, 984 {R/O}

Notch and Partition : Page [0Ch] (Factory, Current, Saved)

Notched Drive (ND) : 1, 1, 1 {R/O}

Logical or Physical Notch (LPN) : 0, 0, 0

Max # of notches : 18, 18, 18 {R/O}

Active Notch : 0, 0, 0

Starting Boundary : 00000000h, 00000000h, 00000000h

Ending Boundary : 00C00501h, 00C00501h, 00C00501h

Pages notched : 0000000000000008h, 0000000000000008h, 0000000000000008h

Protocol Specific Port : Page [19h] (Factory, Current, Saved)

Physical interface : Parallel SCSI

Driver strength : 1, 1, 1 {R/O}

Driver asymmetry : 0, 0, 0 {R/O}

Driver precompensation : 0, 0, 0 {R/O}

Driver slew rate : 0, 0, 0 {R/O}

DB(0) Value : 0, 0, 0 {R/O}

DB(1) Value : 0, 0, 0 {R/O}

DB(2) Value : 0, 0, 0 {R/O}

DB(3) Value : 0, 0, 0 {R/O}

DB(4) Value : 0, 0, 0 {R/O}

DB(5) Value : 0, 0, 0 {R/O}

DB(6) Value : 0, 0, 0 {R/O}

DB(7) Value : 0, 0, 0 {R/O}

DB(8) Value : 0, 0, 0 {R/O}

DB(9) Value : 0, 0, 0 {R/O}

DB(10) Value : 0, 0, 0 {R/O}

DB(11) Value : 0, 0, 0 {R/O}

DB(12) Value : 0, 0, 0 {R/O}

DB(13) Value : 0, 0, 0 {R/O}

DB(14) Value : 0, 0, 0 {R/O}

P_CRCA : 0, 0, 0 {R/O}

P1 : 0, 0, 0 {R/O}

BSY : 0, 0, 0 {R/O}

SEL : 0, 0, 0 {R/O}

RST : 0, 0, 0 {R/O}

REQ : 0, 0, 0 {R/O}

ACK : 0, 0, 0 {R/O}

ATN : 0, 0, 0 {R/O}

C/D : 0, 0, 0 {R/O}

I/O : 0, 0, 0 {R/O}

MSG : 0, 0, 0 {R/O}

Transfer period factor : 0, 0, 0 {R/O}

REQ/ACK offset timing : 0, 0, 0 {R/O}

Transfer width exponent : 1, 1, 1 {R/O}

Protocol options bits : 09h, 09h, 09h

Driver asymmetry : 0, 0, 0 {R/O}

Sent PCOMP enabled : 0, 0, 0 {R/O}

Received PCOMP enabled : 0, 0, 0 {R/O}

Min xfr period factor : 0, 0, 0 {R/O}

Max REQ/ACK offset : 0, 0, 0 {R/O}

Max transfer width exponent : 1, 1, 1 {R/O}

Protocol options bits supported : 08h, 08h, 08h

Power Condition : Page [1Ah] (Factory, Current, Saved)

Idle : 0, 0, 0

Standby : 0, 0, 0

Idle condition timer : FFFFFFFFh, FFFFFFFFh, FFFFFFFFh

Standby condition timer : FFFFFFFFh, FFFFFFFFh, FFFFFFFFh

Informational Exceptions Control : Page [1Ch] (Factory, Current, Saved)

PERF : 0, 0, 0

EBF : 0, 0, 0

EWASC : 1, 1, 1

DExcpt : 0, 0, 0

TEST : 0, 0, 0

EBACKERR : 0, 0, 0 {R/O}

LogErr : 1, 1, 1

MRIE : 2, 2, 2 {R/O}

Interval timer : 00000BB8h, 00000BB8h, 00000BB8h

Report count : 00000002h, 00000002h, 00000002h

Program Ended.

Page url: http://www.santools.com/santool/index.html?example_mode_page_dump_scsi.htm