Example Mode Page Dump

The results below were run under SPARC Solaris 10 using a Seagate ST336704FC Fibre Channel disk.

smartmon-ux -J /dev/rdsk/c1t2d0s0

Discovered SEAGATE ST336704FC S/N "3CD0W3AV" on /dev/rdsk/c1t2d0s0 [SES] (SMART enabled)(35003 MB)

Read-Write Error Recovery : Page [01h] (Factory, Current, Saved)

Automatic reallocation of write (AWRE) : 1, 1, 1

Automatic reallocation of read (ARRE) : 1, 1, 1

Transfer block (TB) : 0, 1, 1

Read continuous (RC) : 0, 0, 0

Enable early recovery (EER) : 0, 0, 0

Post error (PER) : 0, 0, 0

Disable transfer on error (DTE) : 0, 0, 0

Disable correction (DCR) : 0, 0, 0

Read Retry Count : 11, 11, 11

Correction Span : 240, 240, 240 {R/O}

Head Offset Count : 0, 0, 0 {R/O}

Data Strobe Offset Count : 0, 0, 0 {R/O}

Write Retry Count : 5, 5, 5

Recovery Time Limit : 65535, 65535, 65535

Disconnect-Reconnect : Page [02h] (Factory, Current, Saved)

Buffer full ratio : 128, 128, 128

Buffer empty ratio : 128, 128, 128

Bus inactivity limit : 0, 0, 0 {R/O}

Disconnect time limit : 0, 0, 0 {R/O}

Connect time limit : 0, 0, 0 {R/O}

Maximum burst size : 460, 256, 256

Enable modify data pointers (EMDP) : 0, 0, 0 {R/O}

Fair arbitration : 0, 0, 0 {R/O}

Disconnect immediate (DImm) : 0, 0, 0 {R/O}

Data transfer disconnect control (DTDC) : 0, 0, 0 {R/O}

First burst size : 0, 0, 0 {R/O}

Format Device : Page [03h] (Factory, Current, Saved)

Tracks per zone : 905, 905, 905 {R/O}

Alternate sectors per zone : 0, 0, 0 {R/O}

Alternate tracks per zone : 6, 6, 6 {R/O}

Alternate tracks per lun : 0, 0, 0 {R/O}

Sectors per track : 424, 424, 424 {R/O}

Bytes per sector : 512, 512, 512 {R/O}

Interleave : 1, 1, 1 {R/O}

Track skew factor : 85, 85, 85 {R/O}

Cylinder skew factor : 90, 90, 90 {R/O}

Supports soft sectoring (SSEC) : 0, 0, 0 {R/O}

Supports hard sectoring (SHEC) : 1, 1, 1 {R/O}

Removable Medium (RMB) : 0, 0, 0 {R/O}

Addresses assigned by surface (SURF) : 0, 0, 0 {R/O}

Rigid Disk Device Geometry : Page [04h] (Factory, Current, Saved)

Number of cylinders : 14100, 14100, 14100 {R/O}

Number of heads : 12, 12, 12 {R/O}

Starting write precomp : 0, 0, 0 {R/O}

Starting reduced current : 0, 0, 0 {R/O}

Drive step rate : 0, 0, 0 {R/O}

Landing Zone Cylinder : 0, 0, 0 {R/O}

RPL : 0, 0, 0 {R/O}

Rotational Offset : 0, 0, 0 {R/O}

Medium rotation Rate : 10016, 10016, 10016 {R/O}

Verify Error Recovery : Page [07h] (Factory, Current, Saved)

EER : 0, 0, 0

PER : 0, 0, 0

DTE : 0, 0, 0

DCR : 0, 0, 0

Verify Retry Count : 11, 11, 11

Verify Correction Span (bits) : 240, 240, 240 {R/O}

Verify Recovery Time Limit (ms) : 65535, 65535, 65535

Cache Control : Page [08h] (Factory, Current, Saved)

Initiator control (IC) : 0, 0, 0

Abort Pre-fetch (ABPF) : 0, 0, 0 {R/O}

Caching analysis permitted (CAP) : 0, 0, 0

Discontinuity (DISC) : 1, 0, 0

Size enable (Size) : 0, 0, 0 {R/O}

Write cache enable (WCE) : 1, 1, 1

Multiplication factor (MF) : 0, 0, 0 {R/O}

Read cache disable (RCD) : 0, 0, 0

Demand read retention priority : 0, 0, 0 {R/O}

Demand Write Retention Priority : 0, 0, 0 {R/O}

Disable Pre-fetch Transfer Length : 65535, 65535, 65535 {R/O}

Minimum Pre-fetch : 0, 0, 0

Maximum Pre-fetch : 65535, 0, 0

Maximum Pre-fetch Ceiling : 65535, 65535, 65535 {R/O}

Force sequential write (FSW) : 1, 0, 0

LB cache segment size (LBCSS) : 0, 0, 0 {R/O}

Disable read-ahead (DRA) : 0, 0, 0

Vendor-specific bits (VSS) : 0, 0, 0 {R/O}

Number of cache segments : 16, 24, 24

Cache segment size : 0, 0, 0 {R/O}

Non cache segment size : 0, 0, 0 {R/O}

Control Mode : Page [0Ah] (Factory, Current, Saved)

TST : 0, 0, 0 {R/O}

TMF_ONLY : 0, 0, 0 {R/O}

D_SENSE : 0, 0, 0 {R/O}

GLTSD : 1, 0, 0

RLEC : 0, 0, 0

Queue algorithm modifier : 0, 0, 0

QErr : 0, 0, 0 {R/O}

DQue : 0, 0, 0

VS : 0, 0, 0 {R/O}

RAQ : 0, 0, 0 {R/O}

UA_INTLCK_CTRL : 0, 0, 0 {R/O}

SWP : 0, 0, 0

RAERP : 0, 0, 0 {R/O}

UUAERP : 0, 0, 0 {R/O}

EAERP : 0, 0, 0 {R/O}

ATO : 0, 0, 0 {R/O}

TAS : 0, 0, 0 {R/O}

Autoload mode : 0, 0, 0 {R/O}

Ready AER holdoff period : 0, 0, 0 {R/O}

Busy timeout period : 0, 0, 0 {R/O}

Extended self-test completion time : 1350, 1350, 1350 {R/O}

Protocol Specific Port : Page [19h] (Factory, Current, Saved)

Physical interface : Fibre Channel

Disable target orig loopid (DTOLI) : 0, 0, 0

Disable target init porten (DTIPE) : 0, 0, 0

Allow login w/o loop init (ALWLI) : 0, 0, 0

Require hard address (RHA) : 0, 0, 0

Disable loop master (DLM) : 0, 0, 0

Disable discovery (DDIS) : 0, 0, 0

Prevent loop port bypass (PLPB) : 0, 1, 1

Disable fabric discovery (DTFD) : 0, 0, 0

Resource recov timeout granularity : 0, 0, 0 {R/O}

Resource recovery timeout : 0, 0, 0 {R/O}

Power Condition : Page [1Ah] (Factory, Current, Saved)

Idle : 1, 0, 0

Standby : 1, 0, 0

Idle condition timer : 00000001h, 00000001h, 00000001h

Standby condition timer : 00000004h, 00000004h, 00000004h

Informational Exceptions Control : Page [1Ch] (Factory, Current, Saved)

PERF : 0, 0, 0

EBF : 0, 0, 0 {R/O}

EWASC : 1, 1, 1

DExcpt : 0, 0, 0

TEST : 0, 0, 0

EBACKERR : 0, 0, 0 {R/O}

LogErr : 0, 0, 0

MRIE : 0, 6, 6

Interval timer : 00000000h, 00001770h, 00001770h

Report count : 00000001h, 00000000h, 00000000h

Program Ended.

This disk does not support any of the background media scanning functions as they are not listed under mode page 1C, where the parameters are specified per the ANSI specification.

Page url: http://www.santools.com/santool/index.html?example_mode_page_dump_fc.htm